- Wide range PFC Input
- Low THD and AC noise
- Advanced Measurement Available
- Field Parallel Configurable
- Multiple Units Configurable for
Poly-Phase Operation
The ContinousWave (CW) is designed for testing single or
polyphase electronics.
The CW is
well suited for applications requiring a cost-effective low profile
AC source.
Applications include:
Testing for real world sine
wave power conditions
400 Hz testing for avionics equipment
50/60 Hz margin testing
Ballast testing
Components testing
Power supply testing for AC to DC converters
 |
|
Manual CW Features And Benefits
The manual series front panel knobs (10 turn
potentiometers) allow quick adjustment of voltage, current and
frequency settings. Frequency and voltage can be programmed remotely
using a 0 to 5V analog signal. LED’s indicate: output-on, voltage or
current mode operation, fault and slave modes.
Models can also be paralleled in the field or
configured for three phase operation using
a factory supplied cable. Current shutdown or foldback modes can be
selected from a rear panel switch.
Programmable CW Features And Benefits
Front panel encoder knobs allow programming of
voltage, current and frequency settings. Programmed or measured
values can be viewed on the two LED displays through push button
selection.
Menu push buttons enable setting system
configuration including parallel or three phase operation. This menu
also allows setting current shutdown or foldback modes. Remote
IEEE-488.2 and RS-232 control interfaces are standard. LEDs
indicate: high or low range output voltage, measure or program mode,
voltage or current mode operation and
output-on.
LED’s indicate menu/status, remote control,
lockout and fault conditions. Digital Signal Processing (DSP) based
measurements include voltage, current (amperes, peak amperes, crest
factor), power (watts, VA and power factor) and frequency
Download
Brochure |
